WTI NPS-115 Guide de l'utilisateur télécharger pdf (Page 52)

5-25

Basic Configuration

• PortAccess: Determines whether or not the account will be allowed to connect to

the serial Setup Port. (Defaults; Administrator and SuperUser = Always Enabled,

User = Disabled.)

Note: ViewOnly level accounts cannot be granted access to the Setup Port.

• PlugAccess: Determines which outlet(s) this account will be allowed to control.

(Defaults; Administrator and SuperUser = All Plugs On, User = All Plugs Off,

ViewOnly = All Plugs Off.)

Notes:

• Administrator and SuperUser level accounts always have access to all plugs.

• User level accounts will only have access to the plugs that are defined via the

"Plug Access" parameter.

• ViewOnly accounts are allowed to display the Plug Status Screen, but are

limited to the plugs specified by the account. ViewOnly accounts are not

allowed to invoke switching and reboot commands.

• PlugGroupAccess: Determines which plug groups this account will be allowed to

control. For more information on Plug Groups, please refer to Section 5.6.

(Defaults; Administrator and SuperUser = All Plug Groups On, User = All Plug

Groups Off, ViewOnly = All Plug Groups Off.)

Notes:

• In order to use this feature, Plug Groups must first be defined as described in

Section 5.6.

• Administrator and SuperUser level accounts will always have access to all

plug groups.

• User Level accounts will only have access to the plug groups that are

defined via the Plug Group Access parameter.

• ViewOnly accounts are allowed to display the On/Off status of plug groups

via the Plug Status Screen, but are limited to the plug groups specified by the

account. ViewOnly accounts are not allowed to invoke switching and reboot

commands.

• ServiceAccess: Determines whether this account will be able to access command

mode via Serial Port, Telnet/SSH or Web and whether or not the account will be

allowed to initiate outbound connections. For example, if Telnet/SSH Access is

disabled for this account, then this account will not be able to access command

mode via Telnet or SSH. (Default = Serial Port = On, Telnet/SSH = On, Web = On,

Outbound Access = Off.)

Note: The Service Access Parameter is only used to select permitted access

services for an individual user account. To separately enable/disable all SSH or

Telnet Access for the VMR/NPS unit, please refer to Section 5.9.2.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 173 174

Pas de commentaire

WTI NPS-115 Guide de l'utilisateur Page 52