WTI NPS-115 Guide de l'utilisateur télécharger pdf (Page 105)

7-13

Alarm Configuration

To configure the Ping-No-Answer Alarm, you must access the VMR/NPS command

mode using a password that permits Administrator Level commands. The Ping-No-

Answer alarm configuration menu offers the following parameters:

• TriggerEnable: Enables/Disables the trigger for this alarm. When Disabled, this

alarm will be suppressed. (Default = On.)

Note:

• In order for this alarm to function, at least one target IP Address for the Ping

No Answer Alarm must be defined as described in Section 6.1.1.

• To cancel an alarm without correcting the condition that caused the alarm,

simply toggle the Trigger Enable parameter Off and then back On again.

• The Trigger Enable, Notify on Clear, Email Message and Address 1, 2 and 3

Parameters all include "Copy to All Triggers" options that allow you to enable/

disable the corresponding parameter for all VMR/NPS alarms. For example,

if the Ping-No-Answer Alarm's Trigger Enable parameter is set to "On (Copy to

All Triggers), then all other VMR/NPS alarms will also be enabled.

• ResendDelay: Determines how long the VMR/NPS will wait to resend an email

message generated by this alarm, when the initial attempt to send the notification

was unsuccessful. (Default = 60 Minutes.)

• NotifyUponClear: When this item is enabled, the VMR/NPS will send additional

notification when the situation that caused the alarm has been corrected. For

example, when Notify Upon Clear is enabled, the VMR/NPS will send initial

notification when it detects that a Ping command has failed, and then send a

second notification when it determines that the IP address is again responding to

the Ping command. (Default = On.)

• EmailMessage: Enables/Disables email notification for this alarm. (Default = On.)

• Address1,2,and3: These parameters are used to select which of the three email

addresses defined via the "Email Messages" menu (see Section 5.9.11) will receive

the email alarm notification messages generated by this alarm. The Address

parameters can be used to select one, or any combination of the addresses defined

via the Email Messages menu. (Default = All On.)

Note: If Email addresses have been previously specified, then the text under

the parameters will list the current, user defined email addresses.

• Subject: This parameter is used to define the text that will appear in the "Subject"

field for all email notification messages that are generated by this alarm.

(Default = "Alarm: Ping-No-Answer")

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 173 174

Pas de commentaire

WTI NPS-115 Guide de l'utilisateur Page 105