WTI NPS-115 Guide de l'utilisateur télécharger pdf (Page 101)

7-9

Alarm Configuration

7.3. The Circuit Breaker Open Alarm

The Circuit Breaker Alarm is intended to provide notification in the event that one of the

VMR/NPS's circuit breakers is opened. When a circuit breaker is open, the VMR/NPS

can provide prompt notification via Email, Syslog Message or SNMP Trap.

Notes:

• The Circuit Breaker Open Alarm is not applicable to some VMR models.

• In order for the VMR/NPS to provide alarm notification via Email,

communication parameters must first be defined as described in

Section 5.9.11.

• In order for the VMR/NPS to provide alarm notification via Syslog Message,

Syslog parameters must first be defined and Syslog Messages must be

enabled as described in Section 5.9.2 and Section 11.

• In order for the VMR/NPS to provide alarm notification via SNMP Trap, SNMP

parameters must first be defined, and SNMP Traps must be enabled as

described in Section 5.9.7 and Section 12.

To configure the Circuit Breaker Alarm, you must access the VMR/NPS command mode

using a password that permits Administrator Level commands. The Circuit Breaker

Open Alarm Configuration Menu offers the following parameters:

• TriggerEnable: Enables/Disables the trigger for this alarm. When Disabled, this

alarm will be suppressed. (Default = On.)

Note:

• When an alarm is generated, to cancel an alarm without correcting the

condition that caused the alarm, simply toggle the Trigger Enable parameter

Off and then back On again.

• The Trigger Enable, Notify on Clear, Email Message and Address 1, 2 and 3

Parameters all include "Copy to All Triggers" options that allow you to enable/

disable the corresponding parameter for all VMR/NPS alarms. For example,

if the Circuit Breaker Open Alarm's Trigger Enable parameter is set to "On

(Copy to All Triggers), then all other VMR/NPS alarms will also be enabled.

• ResendDelay: Determines how long the VMR/NPS will wait to resend an email

message generated by this alarm, when the initial attempt to send the notification

was unsuccessful. (Default = 60 Minutes.)

• NotifyUponClear: When this item is enabled, the unit will send additional

notification when the situation that caused the alarm has been corrected. For

example, when Notify Upon Clear is enabled, the unit can send initial notification

when it detects an open circuit breaker, and then send a second notification when it

determines that the circuit breaker has been closed. (Default = On.)

• EmailMessage: Enables/Disables email notification for this alarm. (Default = On.)

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 173 174

Pas de commentaire

WTI NPS-115 Guide de l'utilisateur Page 101