WTI NPS-115 Guide de l'utilisateur télécharger pdf (Page 60)

5-33

Basic Configuration

5.8. Serial Port Configuration

The serial Port Configuration menus allow you to select parameters for the VMR/NPS

serial Setup Port. In addition, the Serial Port Configuration menu (Port Parameters) can

also be used to set communications parameters, disable Administrator level commands

at the serial Setup Port and also select a number of other Setup Port Parameters

described below.

CommunicationSettings:

• BaudRate: Any standard rate from 300 bps to 460K bps. (Default = 9600 bps).

• Bits/Parity: (Default = 8-None).

• StopBits: (Default = 1).

• HandshakeMode: XON/XOFF, RTS/CTS (hardware), Both, or None.

(Default = RTS/CTS).

GeneralParameters:

• AdministratorMode: In WTI console server products, this parameter is used to

permit or deny port access to Administrator level accounts. In VMR/NPS products,

Administrator access to the serial port cannot be disabled.

• LogoffCharacter: The Logoff Character determines the command(s) or

character(s) that must be issued at this port in order to disconnect this port from

another port. Note that the Logoff Character does not apply to Direct Connections.

(Default = ^X.)

• SequenceDisconnect: Enables/Disables and configures the disconnect

command. This item offers the option to disable the Sequence Disconnect, select a

one character format or a three character format. (Default = One Character.)

• InactivityTimeout: Enables and selects the Timeout Period for this port. If

enabled, the Setup Port will disconnect when no additional data activity is detected

for the duration of the timeout period. (Default = 5 Minutes.)

• CommandEcho: Enables or Disables command echo at the Setup Port. When

disabled, commands that are sent to the Setup Port will still be invoked, but the

actual keystrokes will not be displayed on your monitor. (Default = On.)

• AcceptBreak: Determines whether the port will accept breaks received from the

attached device. When enabled, breaks received at the port will be passed to any

port that this port is connected to. When disabled, breaks will be refused at this

port. (Default = On.)

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 173 174

Pas de commentaire

WTI NPS-115 Guide de l'utilisateur Page 60