WTI NPS-115 Guide de l'utilisateur télécharger pdf (Page 15)

2-4

Unit Description

2.4. VMR-HD4D Series - Back Panel

As shown in Figure 2.4, the VMR-HD4D Series Back Panel includes the following

components:

1. PowerCircuitA-PowerInlet: Supplies power to VMR control functions and

Circuit "A" outlets.

Notes:

• VMR-HD4D16 and VMR-HD4D20 units feature detachable power supply

cables.

• VMR-HD4D30 units feature attached power supply cables with

NEMA L6-30P Plugs.

• VMR-HD4D32 units feature attached power supply cables with

IEC 60309 Plugs.

2. PowerCircuitB-PowerInlet: Supplies power to VMR control functions and

Circuit "A" outlets. Please refer to the notes under item 1 above.

3. PowerCircuitA-SwitchedOutlets: AC Outlets that can be switched On, Off,

rebooted or set to default state in response to user commands.

4. PowerCircuitB-SwitchedOutlets: Same as Item 3 above.

5. AlarmIndicatorLights: Two LEDs which light when an alarm condition is detected

at the corresponding power circuit. For information on Alarm Configuration, please

refer to Section 7.

6. SetUpPort: An RJ45 RS232 serial port (DCE configuration) used for connection to

a local terminal or external modem, as described in Section 4.3.2. For a description

of the Setup Port interface, please refer to Appendix B.1.

7. NetworkPort: An RJ45 Ethernet port for connection to your 100Base-T, TCP/IP

network. Note that the VMR features a default IP address (192.168.168.168). This

allows you to connect to the unit without first assigning an IP address. Note that the

Network Port also includes two, small LED indicators for Link and Data Activity. For

more information on Network Port configuration, please refer to Section 5.9.

A B

10/100 BaseT

SETUP PORT

ACT

ALM

LINK

A1 A2 B1 B2

2 3 4 5

6 7

Figure 2.4: VMR-HD4D Series - Back Panel (Model VMR-HD4D32 Shown)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 173 174

Pas de commentaire

WTI NPS-115 Guide de l'utilisateur Page 15